Adjusting The Printing Area; Set The Margins - Roland TrueVIS VF2-640 User Manual

Adjusting the Printing Area

Set the margins.

This sets the distance from the left or right media clamp to the corresponding left or right edge of the printing
area.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
SUB MENU
3.
Press [▶] once, and then press [▼] several times to display the screen shown below.
SUB MENU
SIDE MARGIN
4.
Press [▶] to display the screen shown below.
SIDE MARGIN
10mm
5.
Press [▲] or [▼] to select the margin from those shown below.
• "5 mm"
• "10 mm"
• "25 mm"
6.
Press [ENTER] to confirm your entry.
• If the media has already been set, the message [PRESS ENTER KEY TO SETUP] is displayed on the
screen.
• If the media has not yet been set, press [MENU] to go back to the original screen.
MEMO
• Default setting: "10 mm"
RELATED LINKS
・ P. 27 "Setup of Media"
・ P. 204 "Maximum Printing Area and Margins"
100
2. Optimizing Work Efficiency
10mm