Roland TrueVIS VF2-640 User Manual page 67

Printing Output
MEMO
When you send the output data, "FILLING" or "CLEANING" may be displayed on the screen. These indicate the prepara-
tion operations performed before output. Output will begin after the time displayed on the screen elapses.
IMPORTANT
Output Is Not Possible in These Situations
• The machine does not run when a cover (front, left, right, or ink slot) is open.
• Data from the computer is not accepted when [SETUP] is dark.
• Printing does not start until [HEATER] lights. However, in the following cases printing is possible even if [HEATER] is not
lit.
• The settings for "PRINT" (print heater) and "DRYER" are "OFF".
• Heater settings "POWER" is "OFF."
• Data from the computer is not accepted when you are not at the top menu.
Points that must be observed
• Never open a cover (front, left, or right) while output is in progress. Doing so interrupts printing.
• When you are performing printing, clamp the edges of the media with the media clamps. Otherwise, the edges of the
media may warp and catch on the print heads.
• During output, do not touch the media. Doing so may obstruct the media feed or cause the media to rub against the
print heads, which may result in a paper jam or damage to the heads.
• Keep the loading lever raised when the machine is not in use.
When not using the machine, remove any media and store it in a suitable environment.
• If the machine is left with the media loaded, the media may be damaged, which may adversely affect printing. When
not using the machine, remove any media and store it in a suitable environment.
66
1. Printing Method
P. 84 "Setting the Print Heater Temperature"
P. 85 "Setting the Dryer Temperature"
P. 90 "Switching Off the Print Heater and Dryer Together"