Table of Contents
Advertisement
Adjusting the Ink-drying Method
Setting the Print Heater Temperature
Setting the temperature of the print heater appropriately improves ink adhesion and inhibits smudging.
• With the default settings, simply switching on the power does not make the dryer warm up to the set
temperature. On completion of media setup, the temperature rises to the set value.
• Depending on the usage environment, the temperature of the dryer may become higher than the set
temperature, but this does not represent a problem.
Procedure
1.
Load the media.
2.
Tap the following location on the home screen.
The [Heater Temperature] screen appears.
3.
Tap
or
If the ink forms lumps or smudges, raise the temperature. Note, however, that a temperature that
is too high may degrade the media or cause it to wrinkle.
4.
Tap [Save] to confirm your entry.
5.
Tap
to go back to the original screen.
MEMO
• Default setting: 25°C (77°F)
• You can also make this setting in the software RIP. When you have made the setting in the software RIP, the
software RIP's setting is used.
126
Optimizing the Output Quality
to set the [Print Heater] temperature.
Advertisement
Table of Contents
