Configuring Settings To Match The Properties Of The Media; Changing The Print Head Height - Roland TrueVIS VF2-640 User Manual

Configuring Settings to Match the Properties of
the Media

Changing the Print Head Height

This adjusts the print head height when printing on thick media and to prevent media that is wrinkled or comes
loose from the platen from contacting the print heads.
You can select the print head height from "LOW", "MIDDLE" or "HIGH". Printing quality when the print head height
is set to "MIDDLE" or "HIGH" may be coarser or otherwise lower than when set to "LOW".
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
HEAD HEIGHT
3.
Press [▶]. After "NOW PROCESSING.." is displayed, the screen shown below appears.
HEAD HEIGHT
LOW
4.
Open the front cover.
5.
Move the height-adjustment lever to adjust the head height.
When you change the position of the height-adjustment lever, the display screen changes and the buzzer
sounds at the same time.
HIGH
MIDDLE
LOW
MEMO
• Normally move the height-adjustment lever to "LOW." For media that is wrinkled or comes loose from the platen,
move the height-adjustment lever to "MEDIUM" or "HIGH."
• The printing quality degrades as the distance between the media and the print heads increases. Do not move the
height-adjustment lever to "MEDIUM" or "HIGH" needlessly.
6.
Close the front cover.
7.
Press [MENU] to go back to the original screen.
74
1. Optimizing the Output Quality
LOW
Position
HEAD HEIGHT
LOW
HEAD HEIGHT
LOW
HEAD HEIGHT
LOW
Display screen
HIGH
MIDDLE
LOW