Drying The Trailing Edge Of The Printing Area On The Dryer - Roland TrueVIS VF2-640 User Manual

Adjusting the Ink-drying Method

Drying the Trailing Edge of the Printing Area on the Dryer

To dry the ink thoroughly, configure the settings so that the media is fed until the trailing edge of the printed area
is put on the dryer after the printing is finished.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
HEATER MENU
3.
Press [▶] twice to display the screen shown below.
FEED FOR DRY
DISABLE DISABLE
4.
Press [▲] or [▼] to select "ENABLE" or "DISABLE".
"ENABLE"
"DISABLE"
5.
Press [ENTER] to confirm your entry.
6.
Press [MENU] to go back to the original screen.
MEMO
• Default setting: "DISABLE"
88
1. Optimizing the Output Quality
Media feed is performed until the trailing edge of the printing area is positioned on the
dryer. The margin between the print-end position and the next print-start position is set
to a value of 100 mm (3.9 in.) when [OPTION DRYER] is set to "DISABLE" and 280 mm
(11.0 in.) when it is set to "ENABLE".
P. 91 "Using an Auxiliary Drying Unit"
Media feed stops when printing ends. This means that the trailing edge of the printing
area is not fed to the dryer unless you continue with a subsequent printing operation.