Roland TrueVIS VF2-640 User Manual page 62

5.
Adjust the misalignment of the ink landing position.
Procedure
1.
Press [◀] to select "SET".
MEDIA GAP ADJ.
[SET] NEXT
2.
Press [ENTER] to confirm your entry.
Printing of the test pattern starts.
You can select "NEXT" and press [ENTER] to skip the current menu and proceed to the next menu.
3.
Press [ENTER].
INPUT
ADJ. VALUES
4.
View the printed test pattern, and then determine the correction value.
Select the value that gives the least misalignment between the two lines. In the case of the following
figure, select "-3." When you cannot choose between two sequential numbers, select a value that is be-
tween them (you can set correction values in units of "0.5").
5.
Press [▲] or [▼] to select the correction value.
MEDIA GAP ADJ.
0
6.
Press [ENTER] to confirm your entry.
7.
Press [◀] to select "SET".
REDO ADJ.?
[YES] DONE
8.
Press [ENTER] to confirm your entry.
The test pattern is printed again. Check that the misalignment is minimized for the two vertical lines indi-
cated by " " (that is, the current correction value). If the difference between the two vertical lines is
smaller in other locations, return to step 5 to configure the setting again.
If you do not need to change the correction value, press [ENTER] again.
9.
Press [▶] to select "DONE".
REDO ADJ.?
YES [DONE]
10.
Press [ENTER] to confirm your entry.
5
Printing Output
61
1. Printing Method