Step 5: Reinstalling The Machine - Roland TrueVIS VF2-640 User Manual

Preparing to Move the Machine

Step 5: Reinstalling the Machine

Procedure
1.
Once the preparations are complete, move the machine with as little delay as possible.
2.
Reinstall the printer immediately, and then remove the retainer securing the print heads in place.
For storage, attach the retainer in the position indicated in the figure.
3.
Turn on the main power switch.
IMPORTANT
To prevent the print heads from being damaged, move the machine with as little delay as possible and switch on the main
power as soon as possible after moving the machine. To install the machine again, follow the procedure in the Setup
Guide.
4.
Press the sub power button.
The screen shown below appears, and then the machine is filled with TR2 cleaning liquid. The (approxi-
mate) remaining time for the procedure is displayed on the screen. (The display shown below is an exam-
ple. "01:40" = "1 minute and 40 seconds")
FILLING LIQUID
>>>>>
MEMO
If the cleaning liquid pouch is empty, or is not attached, the following screen will be displayed. Install a cleaning liquid
pouch and press [ENTER].
SET CL-LIQUID
FOR WIPER
Once the machine is filled with TR2 cleaning liquid, the following screen is displayed and the power turns on.
SETUP SHEET
MEMO
After the printer is reinstalled, the media holder adjuster must be adjusted by a suitably qualified worker. This work must
be performed by a Roland DG Corporation worker. Contact your authorized Roland DG Corporation dealer.
RELATED LINKS
・ P. 49 "TR2 Cleaning Liquid Pouch Replacement"
202
1. Operations When Moving the Unit
01:40