Roland TrueVIS VF2-640 User Manual page 41

What to Do First after Installation
8.
Set the correction values from "H1" to "H4."
(1)
Press [◀] or [▶] to select a value from H1 to H4.
(2) Press [▲] or [▼] to select the correction value.
H1
0
(3) When you have finished setting the correction values, press [ENTER].
The screen shown below appears again.
DETAIL SETTING
SETTING NO.1
9.
Press [▼] to display the screen shown below.
DETAIL SETTING
SETTING NO.2
10.
Set the correction values from "MEDIA GAP ADJ. NO.2 H1" to "MEDIA GAP ADJ. NO.2 H4" in the same manner as
step 8.
11.
Press [▼] to display the screen shown below.
DETAIL SETTING
TEST PRINT
12.
Press [ENTER].
Printing of the test pattern starts.
13.
Check the test pattern to see whether the correction was successful.
For all the correction values, check that the misalignment is minimized for the two vertical lines indicated
by " " (that is, the current correction value). If the misalignment is smaller for another set of vertical
lines, set the correction value again.
14.
When you have successfully performed the correction, press [MENU] to go back to the original screen.
40
2. Basic Operations
H2 H3
0 0
H4
0