Error Messages; Area Too Small Continue; Print Area Too Small; Canceled For Table Height - Roland VersaUV LEF2-200 User Manual

Error Messages

This section describes the error messages that may appear on the machine's display, and how to take action to
remedy the problem. If the action described here does not correct the problem or if an error message not descri-
bed here appears, contact your authorized Roland DG Corporation dealer.

AREA TOO SMALL CONTINUE?

The size of the data is larger than the print area of the loaded object to be printed on.
To continue printing without correcting this, press [ENTER]. The portion extending beyond the print area will not
be printed. To stop printing, stop sending data from the computer and hold down [SETUP] for one second or lon-
ger. Make the print area wider by replacing the object to be printed on with a larger object or by changing the
position of the object, then send the data again.

PRINT AREA TOO SMALL

The size of the test print is larger than the print area of the loaded object to be printed on.
Press any key on the operation panel to go back to the main menu. Make the print area wider by replacing the
object to be printed on with a larger object or by changing the position of the object, then redo the test printing.

CANCELED FOR TABLE HEIGHT

The object to be printed on was detected in a position (at a height) at which it hits the print heads.
Press any key (except the sub power switch) on the operation panel, and the message disappears. If the setup of
the object to be printed on is completed, the setup is canceled. Redo the setup.
RELATED LINKS
・ P. 44 "Step 2: Start Printing"
・ P. 59 "Adjusting the Height"

CHECK TABLE HEIGHT

The object to be printed on was detected in a position (at a height) at which it hits the print heads.
Remove the object to be printed on (remove the cause of the failure) or change its position. After verifying the
message, press [ENTER].
RELATED LINKS
・ P. 44 "Step 2: Start Printing"
・ P. 59 "Adjusting the Height"

CHECK HEIGHT OF HEAD REFRESHER

The possibility of the print heads colliding into the head refresher (or other obstacle) when they move for head
refreshing is detected.
Press [ENTER] to clear the message.
The jig may be in the way or it may not have been attached correctly. Correctly reattach the head refresher by
removing the jig or reviewing how the jig is attached. Then, perform head refreshing again.
RELATED LINKS
・ P. 133 "Head Refreshing Method"
3. Messages on the Operation Panel
193