Error Messages; Align Point Position Invalid; Ink Shelf Life Expire 12345678; Temperature Is Too High **°C - Roland VersaUV LEC2-300 User Manual

Error Messages

This section describes the error messages that may appear on the machine's display, and how to take action to
remedy the problem. If the action described here does not correct the problem or if an error message not descri-
bed here appears, contact your authorized Roland DG Corporation dealer.

ALIGN POINT POSITION INVALID

An attempt was made to set an align point at a location where the setting cannot be made.
No align point can be set such that the angle between the base point and the align point is too large. Reload the
media correctly, so that the angle is minimized, and then set the base point and the align points again to match
the crop marks.
RELATED LINKS
・ P. 95 "How to Cut with Crop Marks"

INK SHELF LIFE EXPIRE 12345678

One of the ink cartridges has expired.
The numbers of the cartridges whose ink has exceeded its shelf life flash. After pressing [ENTER], replace the car-
tridge indicated by the flashing number.
This message is displayed when the sub power is turned on for the first time after the ink has expired. A buzzer
sounds at the same time the message is displayed.
You can still continue to use the printer without replacing the ink cartridge. However, continuing to use an ink
cartridge that has exceeded its shelf life may lead to the following problems and malfunction.
• Ink leaks from the ink cartridge.
• The ink viscosity increases, leading to ink discharge issues (which may result in decreased output quality).
• The ink hardens, leading to printer malfunctions.
We recommend that you replace any expired ink cartridges. For information about purchasing ink cartridges, con-
tact your authorized Roland DG Corporation dealer or visit our website (
TEMPERATURE IS TOO HIGH **°C
The temperature of the location where the machine is installed has risen above the ambient temperature at
which the machine can operate.
Operation cannot be continued. Turn off the sub power. The displayed temperature is the current ambient temper-
ature of the installation location. Bring the installed location to a temperature at which operation is possible (20 to
32°C [68 to 90°F]), allow the machine to come to room temperature, and then turn on the power.

CROPMARK ERROR NOT FOUND

Automatic detection of crop marks could not be accomplished.
Load the media at the correct position and perform detection of crop marks again. If repeating automatic crop-
mark detection results in an error again, perform manual crop-mark detection. If crop marks cannot be detected
even manually, try using [CROP SENSOR ADJ.] (the correction function of the sensor for reading crop marks) to
perform the correction. Depending on the media, it may not be possible to detect crop marks automatically.
RELATED LINKS
・ P. 95 "How to Cut with Crop Marks"
・ P. 145 "Aligning the Positions of Cutting with Crop Marks Manually"
・ P. 157 "Correcting the Sensor for Reading Crop Marks"
・ P. 255 "Automatic Detection of Crop Marks Fails"
272
5. Messages on the Operation Panel
).
https://www.rolanddg.co.jp/