Port Status; Chapter 44 Port Status; Overview - ZyXEL Communications GS1350 Series User Manual

44.1 Overview

This chapter introduces the port status screens.

44.2 Port Status

This screen displays a port statistical summary with links to each port showing statistical details. To view
the port statistics, click Status in all Web Configurator screens and then the Port Status link in the Quick
Links section of the Status screen to display the Port Status screen as shown next. You can also click
Management > Port Status to see the following screen.
Figure 233 Port Status
The following table describes the labels in this screen.
Table 157 Port Status
LABEL
Port
Name
Link
State
PD
DESCRIPTION
This identifies the Ethernet port. Click a port number to display the Port Details screen (refer to
Figure 234 on page 317).
This is the name you assigned to this port in the Basic Setting > Port Setup screen.
This field displays the speed (either 10M for 10 Mbps, 100M for 100 Mbps, or 1G for 1 Gbps) and
the duplex (F for full duplex or H for half). It also shows the cable type (Copper or Fiber) for the
combo ports. This field displays Down if the port is not connected to any device.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. See
13.1 on page 144 for more information.
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays STOP.
When LACP (Link Aggregation Control Protocol) and STP are in blocking state, it displays
Blocking.
This field displays whether or not a powered device (PD) is allowed to receive power from the
Switch on this port.
GS1350 Series User's Guide
C
H A P T E R

Port Status

315
44
Section