Port Setup - ZyXEL Communications GS1350 Series User Manual

Figure 75 Network Proxy Configuration Application
As of this writing, this setting only allows communication between the Switch and the NCC.
Figure 76 Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
The following table describes the labels in this screen.
Table 31 Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
LABEL
Active
Server
Port
Authentication
Username
Password
Apply
Cancel

8.7 Port Setup

Use this screen to configure Switch port settings. Click Basic Setting > Port Setup in the navigation panel
to display the configuration screen.
Chapter 8 Basic Setting
DESCRIPTION
Select this option to enable communication between the Switch and NCC through a proxy
server.
Enter the IP address (dotted decimal notation) or host name of the proxy server. When entering
the host name, up to 128 alphanumeric characters are allowed for the Server including special
characters inside the square quotes [~!@#$%^&*()_+{}|:"<>?-=[]\;',./']
Enter the port number of the proxy server (1 – 65535).
Select this option to enable proxy server authentication using a Username and Password.
Enter a login user name from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the Username including special characters inside the square quotes
[~!@#$%^&*()_+{}|:"<>?-=[]\;',./'].
Enter a login password from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the Password including special characters inside the square quotes
[~!@#$%^&*()_+{}|:"<>?-=[]\;',./'].
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
GS1350 Series User's Guide
99