ZyXEL Communications GS1350 Series User Manual page 323

Figure 239 Summary
The following table describes the labels in this screen.
Table 162 Summary
LABEL DESCRIPTION
Auto Refresh Enter the number of seconds when the Summary screen details will be updated. Click the Pause
or Play icon to stop or resume the screen update, or to update the automatic refresh interval.
Connect Ports This chart displays the number of ports with connection (IP CAM + NVR + Others) over the total
number of ports on this Switch.
Used Power(W) This chart displays the used PoE Watts over the total number of Watts provided on this Switch.
Port This field displays the port of this Switch.
Port Name This field displays the port description of this Switch.
PD Health This field displays the status of auto PD recovery on this port.
• Red: The Switch failed to get information from the PD connected to the port using LLDP, or
the connected PD did not respond to the Switch's ping requests.
• Yellow: The Switch is restarting the connected PD by turning the power off and turning it on
again.
• Green: The Switch successfully discovered the connected PD using LLDP or ping.
• –: Auto PD Recovery is not enabled on the Switch and the port, or the Switch does not supply
power to the connected PD.
Note: The status will NOT be updated instantaneously after enabling or disabling the
Active switch in the Port > Auto PD Recovery screen. It will wait until the
configured Resume Polling Interval (sec) has lapsed.
Link Speed This shows the speed (either 10M for 10Mbps, 100M for 100Mbps, or 1G for 1 Gbps) and the
duplex (F for full duplex or H for half). This field displays Down if the port is not connected to any
device.
PoE Draw This shows the consumption that the neighboring device connected to this port draws from the
Switch. This allows you to plan and use within the power budget of the Switch.
Bandwidth Tx/Rx This field displays the percentage of bandwidth usage on this port as a percentage of the Link
(%) Speed.
CRC This field displays the number of packets received with CRC (Cyclic Redundant Check) errors.
Chapter 45 Surveillance Mode
GS1350 Series User's Guide
323