Networking; Chapter 50 Networking; Ip Interfaces; What You Can Do - ZyXEL Communications GS1350 Series User Manual

This section shows you how to configure the default gateway device, the default domain name server
and add IP domains.

50.1 IP Interfaces

The Switch needs an IP address for it to be managed over the network. When the Switch (in standalone
mode) fails to obtain an IP address from a DHCP server, the static IP address 192.168.1.1 will be
automatically added and used as the Switch's management IP address.
On the Switch, an IP address is not bound to any physical ports. Since each IP address on the Switch
must be in a separate subnet, the configured IP address is also known as IP interface (or routing
domain). In addition, this allows routing between subnets based on the IP address without additional
routers.
You can configure multiple routing domains on the same VLAN as long as the IP address ranges for the
domains do not overlap. To change the IP address of the Switch in a routing domain, simply add a new
routing domain entry with a different IP address in the same subnet.
You can configure up to 64 IP domains which are used to access and manage the Switch from the ports
belonging to the pre-defined VLANs.
Note: You must configure a VLAN first. Each VLAN can have multiple management IP
addresses, and you can log into the Switch via different management IP addresses
simultaneously.

50.1.1 What You Can Do

• Use the IP Setup screen
default domain name server and add IP domains.
• Use the ONVIF screen

50.2 IP Setup

Use the IP Setup screen to configure the default gateway device, the default domain name server and
add IP domains. See

Chapter 50 Networking

(Section 50.2 on page
(Section 50.3 on page
Section 8.6 on page 94 for more information on IP setup.
GS1350 Series User's Guide
360
C
H A P T E R

Networking

360) to configure the default gateway device, the
362) to enable the ONVIF protocol on the Switch.
50