ZyXEL Communications GS1350 Series User Manual page 40

Table 4 LED Descriptions (continued)
LED COLOR
CLOUD Green
Amber
LOCATOR Blue
PoE Usage MAX Green
Bar1 is the bar at (Bar1-Bar3)
the bottom; bar
5 is the bar at
the top.
Yellow
(Bar4)
Red
(Bar5)
Ethernet Ports and PoE
LNK/ACT Green
1-5 (GS1350-
6HP)
Amber
1-8 (GS1350-
12HP)
1-16 (GS1350-
18HP)
1-24 (GS1350-
26HP)
PoE Green
Amber
1-5 (GS1350-
6HP)
1-8 (GS1350-
12HP)
1-16 (GS1350-
18HP)
1-24 (GS1350-
26HP)
Chapter 3 Hardware Panels
STATUS DESCRIPTION
On The Switch has successfully connected to the NCC (Nebula Control Center).
Blinking The Switch cannot connect to the NCC because it is not registered.
On The Switch is registered at NCC but cannot connect to the NCC. Please
check the Internet connection of the Switch.
Blinking The Switch is not registered at NCC and cannot connect to the NCC. Please
check the Internet connection of the Switch and register the Switch at NCC.
Off The Switch is operating in standalone mode. Nebula Control Center
Discovery is disabled in Basic > Cloud Management > Nebula Control Center
Discovery in the Switch's Web Configurator.
On The Switch is uploading firmware. While the Switch is doing this, do NOT turn
off the power.
Blinking Shows the actual location of the Switch between several devices in a rack.
The default timer is 30 minutes when you are configuring the Switch.
Off The locator is not functioning or malfunctioning.
On Each bar represents 20 percent of PoE Power consumption.
Bar 1: PoE power usage is below 20 percent of the power supplied budget.
Bar 2: PoE power usage is below 40 percent of the power supplied budget,
but over 20 percent of the power supplied budget.
Bar 3: PoE power usage is below 60 percent of the power supplied budget,
but over 40 percent of the power supplied budget.
On PoE power usage is below 80 percent of the power supplied budget, but
over 60 percent of the power supplied budget.
On PoE power usage is more than 80 percent of the power supplied budget.
Blinking Less than 5 percent of the power supplied budget remains. 5 percent is the
default value.
Off PoE power usage is 0 percent of the power supplied budget.
Blinking The Switch is transmitting or receiving to or from a 1000 Mbps Ethernet
network.
On The link to a 1000 Mbps Ethernet network is up.
Blinking The Switch is transmitting or receiving to or from a 10 Mbps or a 100 Mbps
Ethernet network.
On The link to a 10 Mbps or a 100 Mbps Ethernet network is up.
Off The link to an Ethernet network is down.
On Power supplied to all PoE Ethernet ports meets the IEEE 802.3at/bt standard.
On Power supplied to all PoE Ethernet ports meets the IEEE 802.3af standard.
Off There is no power supplied.
GS1350 Series User's Guide
40