Lldp Configuration - ZyXEL Communications GS1350 Series User Manual

27.6 LLDP Configuration

Use this screen to configure global LLDP settings on the Switch. Click Advanced Application > LLDP >
LLDP Configuration (Click Here) to display the screen as shown next.
Figure 161 Advanced Application > LLDP > LLDP Configuration
The following table describes the labels in this screen.
Table 101 Advanced Application > LLDP > LLDP Configuration
LABEL
Active
Transmit Interval
Transmit Hold
Transmit Delay
Reinitialize Delay
Apply
Cancel
Port
*
Chapter 27 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Select to enable LLDP on the Switch. It is enabled by default.
Enter how many seconds the Switch waits before sending LLDP packets.
Enter the time-to-live (TTL) multiplier of LLDP frames. The device information on the
neighboring devices ages out and is discarded when its corresponding TTL expires. The TTL
value is to multiply the TTL multiplier by the LLDP packets transmitting interval.
Enter the delay (in seconds) between successive LLDPDU transmissions initiated by value or
status changes in the Switch MIB.
Enter the number of seconds for LLDP to wait before initializing on a port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This displays the Switch's port number. * means all ports.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
GS1350 Series User's Guide
222