ZyXEL Communications GS1350 Series User Manual page 357

Figure 265 Switching > VLAN > Static VLAN > Add/Edit Static VLAN
The following table describes the related labels in this screen.
Table 180 Switching > VLAN > Static VLAN > Add/Edit Static VLAN
LABEL DESCRIPTION
ACTIVE Select this switch to activate the VLAN settings.
Name Enter a descriptive name for the VLAN group for identification purposes. This name consists of up
to 64 printable characters. Spaces are allowed.
VLAN Group ID Enter the VLAN ID for this static entry; the valid range is between 1 and 4094.
Port The port number identifies the port you are configuring.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Control Select Normal for the port to dynamically join this VLAN group. This is the default selection.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
Tagging Select TX Tagging if you want outgoing traffic to contain this VLAN tag.
Otherwise, to ensure that VLAN-unaware devices (such as computers and hubs) can receive
frames properly, clear the TX Tagging check box to set the Switch to remove VLAN tags before
sending.
Add/Edit Click Add or Edit to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to reset the fields to the factory defaults.
Cancel Click Cancel to change the fields back to their last saved values.
GS1350 Series User's Guide
357