Enable Or Disable Sending Of Snmp Traps On A Port - ZyXEL Communications GS1350 Series User Manual

Table 189 Security > Access Control > SNMP > Trap Group (continued)
LABEL
Options
Apply
Cancel

51.6 Enable or Disable Sending of SNMP Traps on a Port

Click Security > Access Control > SNMP > Trap Group Port to view the screen as shown. Use this screen to
set whether a trap received on the ports would be sent to the SNMP manager.
Figure 274 Security > Access Control > SNMP > Trap Group Port
The following table describes the labels in this screen.
Table 190 Security > Access Control > SNMP > Trap Group Port
LABEL
Option
Port
Chapter 51 Security
DESCRIPTION
Select the individual SNMP traps that the Switch is to send to the SNMP station.
The traps are grouped by category. Selecting a category automatically selects all of the
category's traps. Clear the check boxes for individual traps that you do not want the Switch
to send to the SNMP station. Clearing a category's check box automatically clears all of the
category's trap check boxes (the Switch only sends traps from selected categories).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select the trap type you want to configure here.
This field displays a port number.
GS1350 Series User's Guide
371