Siemens SINUMERIK 840D sl Function Manual page 1006

Detailed description
2.4 Starting up the PLC program
MCP (Machine Control Panel) and HHU (HandHeld Unit)
(only for SINUMERIK 810D to SW 3.x)
If the MCP or HHU is configured (deviation from the norm), an additional SIMATIC 300
station must be inserted into the machine project for each operator component. Any type of
CPU must be inserted in location 2 on row 0 in this station by means of the hardware
configuration (HW config.). The MPI address of the operator component must be set as the
MPI address. MPI network (1) can then be marked in the SIMATIC manager. The global data
can then be activated via the "Tools" menu item.
The rest of the procedure is described in detail in the Commissioning Manual.
2.4 Starting up the PLC program
2.4.1 Installing the basic program for 810D, 840D
Before initial startup of the NC, an NC and PLC general reset must be carried out to initialize
the relevant memory areas. To do this, set switch S3 to setting 1 and switch S4 to setting 3
and switch the control off and on again (POWER ON reset).
Installation
With Toolbox SW 6.1 and higher, the installation is performed by a WINDOWS-compliant
setup program for the basic program, hardware selection in STEP7 (SINUMERIK
810D/840D option package) and the NC-Var Selector. To start the installation, run
"setup.exe" in the main CD directory. You can then choose which components to install.
After the installation, you can select the basic program library directly from STEP 7
(gp8x0d61, 61 is the main basic program version).
The concrete version of the basic program can be scanned for the object properties of the
library or the program folder in the comment field.
From software version 3.7 to version 4.2, installation is carried out using INSTALL.BAT
(INSTALL1.BAT, INSTALL4.BAT).
This program installs the basic program and additional files for the relevant STEP7 version.
With automatic installation in STEP 7 V3 and higher, the TYP, GSD and meta files in the
hardware catalog are also augmented and updated.
The hardware components of the SINUMERIK system are then also available for hardware
configuration under STEP 7. This eliminates the need for unzipping, mentioned below.
The basic program is supplied in zipped format as a project for STEP 7 Version 1.x or as a
library for STEP 7 Version 2.x and subsequent versions.
General
The OB source programs, including standard parameterization, interface symbols and DB
templates for handheld unit and M decoding functions are enclosed in the SIMATIC project
or SIMATIC library of the basic program.
STEP 7 must be installed before the basic program.
22
Basic logic functions: PLC Basic program powerline (P3 pl)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0