Siemens SINUMERIK 840D sl Function Manual page 674

Detailed description
2.7 Program operation mode
Event
Part program end
Table 2-7 Sequence at part program end
Sequence Command
1
AUTO and overstoring or
2
3
RESET_MODE_MASK,
GCODE_RESET_VALUES,
GCODE_RESET_MODE
4 /_N_CMA_DIR/_N_PROG_
EVENT_SPF or name from
5
RESET_MODE_MASK,
GCODE_RESET_VALUES,
GCODE_RESET_MODE
116
Channel selection:
Active status
Mode selection:
AUTO or
MDA or TEACHIN
NC Start
MD20110 $MC_
MD20150 $MC_
MD20152 $MC_
MD11620
MD20110 $MC_
MD20150 $MC_
MD20152 $MC_
Basic logic functions: Mode group, channel, program operation, reset response (K1)
Boundary conditions
(must be satisfied before the
command)
Initial state specification:
Channel in Active status
mode:
AUTO or
AUTO and overstoring or
MDA or TEACHIN
Block with end of part program
Control activated:
Reset sequence with evaluation
as an ASUB
Control activated:
Reset sequence with evaluation
Comments
Select channel and mode,
channel: in active status and
mode: as per selection
Block is changed
Control enabled
Reset sequence with evaluation
of MD 20110 and MD 20150 and
MD 20152
Implied call of the path name as
an ASUB
Control activated
Reset sequence with evaluation
of MD20110 and MD20150 and
MD20152. Significance:
The G-code indexed position
continues to be specified with
machine data
Function Manual, 11/2006, 6FC5397-0BP10-2BA0