Siemens SINUMERIK 840D sl Function Manual page 716

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

Detailed description
2.9 Program control
• Indirect G code programming in form G[ <group> ] = <printout> is substituted by the
Original block:
N510 R1=2
N520 G[8]= R1
• Modal G codes that do not generate an executable block are collected and output with
Original block:
N610 G64
N620 TRANSMIT
• A display block is always generated for part program lines in which the addresses F and
Original block:
N630 F1000
N640 X100
• The display blocks generated for the block display are derived directly from the
Original block:
N710 Y157.5 G42
N720 Z-67.5 RND=7.5
• With the EXECTAB command (processing a table of contour elements), the block
Original block:
N810 EXECTAB (KTAB[5])
• For the EXECSTRING command, the block generated via EXECSTRING is displayed in
Original block:
N910 DEF STRING[40] PROGSTRING = "N905 M3 S1000 G94 Z100 F1000 G55"
N920 EXECSTRING(PROGSTRING)
Display block:
N905 Z100 G55 G94 M3 S1000 F1000
158
If several spindles were configured, then the address expansion is always output with
them.
If no address expansion has been programmed, the number of the master spindle is used
(S<spindle_number>=).
corresponding G code.
the display block of the next executable block if permitted by the syntax (DIN block). If
this is not the case (e.g., predefined subroutine call TRANSMIT), a separate display block
containing the modified G codes is placed in front of the next executable block.
FA appear
(including for MD22240 $MC_AUXFU_F_SYNC_TYPE = 3).
programmed part program blocks. If intermediate blocks (e.g., tool radius compensation
G41/G42, radius/chamfer RNDM, RND, CHF, CHR) are generated in the course of
contour preprocessing, these are assigned the display information from the part program
block on which the motion is based.
generated by EXECTAB is shown in the display block.
the display block.
Display block:
N520 G54
Display block:
G64
N620 TRANSMIT
Display block:
N630 F1000
N640 X100
Display block:
N710 Y157.5 G42
N720 Z-67.5 RND=7.5
Display block:
N810 G01 X46.147 Z-25.38
Basic logic functions: Mode group, channel, program operation, reset response (K1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840di slSinumerik 840dSinumerik 840diSinumerik 810dSinumerik 840d powerlineSinumerik 840de powerline ... Show all

Table of Contents