Siemens SINUMERIK 840D sl Function Manual page 1127

PI service: TMPOSM
Function Position magazine location or tool:
(dependent on parameter assignment)
A magazine location, which has either been specified directly or qualified via a tool located
on it, is traversed to a specified position (e.g., in front of a load location) via the PI service.
The PI service makes a magazine location, which can be qualified in various ways, traverse
in front of a specified load location. The load location must be specified in the
PI parameters "location number_from" and "magazine number_from" (obligatory!).
The magazine location to be traversed can be qualified by the following:
• T number of the tool
Or
• Tool identifier and duplo number
Or
• Direct specification of the location in the location_number_from
Parameterization
Signal
PIService
Unit
Addr1
WVar1
WVar2
WVar3
WVar4
WVar5
WVar6
Basic logic functions: PLC Basic program powerline (P3 pl)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
The location where the tool is positioned traverses;
the parameter "tool identifier", "duplo number", "location number_from" and
magazine number_from" parameters are irrelevant (i.e., values "" , "-0001", "-0001", "-
0001").
The location where the tool is positioned traverses;
the parameters "T number", "location number_from" and "magazine number_from" are
irrelevant (i.e., value "-0001" each).
and magazine_number_from parameters
The tool-qualifying
parameters "T number", "tool identifier" and "duplo number" are irrelevant
(i.e., values "-0001", "", "-0001").
Type
ANY
INT
STRING
INT
INT
INT
INT
INT
INT
Value range
PI.TMPOSM
1, 2
max. 32 characters
Detailed description
2.12 Block descriptions
Meaning
Position magazine
location or tool
TOA
Tool identifier
T number
Duplo number
Location_number_from
Magazine_number_fro
m
Location number_ref
Magazine number_ref
143