Bowflex LateralX LX5 Service Manual page 87

4. Using a #2 Phillips screwdriver, remove the 6 indicated screws
the Shrouds at the push fasteners. Remove the Shrouds and Mast
Gasket, and set them safely aside.
5. Carefully disconnect the Lower Resistance Data Cable (engine wire
harness) from the Speed/Direction Sensor wire,Servo Motor wire and the
Power wire.
Observe the routing of the Lower Resistance Data Cable to the base of
the Console Mast.
NOTICE: Do not crimp the wires. Do not allow them to fall down into the
Engine Assembly. This step may require two people.
Servo Motor wire
Speed/Direction
Sensor wire
Servo Motor
Power wire
87
X4
X2
Lower Resistance
Data Cable
Power Inlet wire