Bowflex LateralX LX5 Service Manual page 109

9. Remove the Endcaps from the Mid Pedal Arms. Using the appropriate
tool, remove the indicated hardware.
Note: The hardware is very tight (factory installed).
or
10. To remove the Mid Pedal Arm, use the dead blow hammer (or mallet)
to strike it on the surface closer to the main frame alternately on either
side of the bearing housing until you drive it off the Crank arm. Set the old
Mid Pedal Arm safely aside.
Note: It may be helpful to rotate the Mid Pedal Arm to allow easier access
to the other side of the bearing housing. Be sure the Mid Pedal Arm
stays aligned on the Crank arm as you remove it, to avoid damage
to the Crank.
11. Put the new Left Mid Pedal Arm on the Crank and push it on by hand,
wiggling it until it goes on as far as possible.
12. Finger tighten the screw and washer to attach the Mid Pedal Arm.
Using the appropriate tool, tighten the hardware to secure the Mid Pedal
Arm to the Crank.
or
Install the Endcap.
Mid Pedal Arm
Mid Pedal Arm
Bearing
109
Bearing
housing