Bowflex LateralX LX5 Service Manual page 136

4. Using a #2 Phillips screwdriver, remove the 3 indicated screws (arrows)
from the Right Upper Shroud. Set the screws safely aside for reassembly.
Remove the Right Shroud, and set it safely aside.
5. Carefully disconnect the Speed/Direction Sensor wire from the Lower
Data Cable.
NOTICE: Do not crimp the cables. Observe the routing of the Speed/
Direction Sensor wire to the Dual Speed/Direction Sensor on
the rear frame below the Console Mast.
LX5 engine shown
Servo Motor wire
Speed/Direction
Sensor wire
Servo Motor
Power wire
136
Lower Data Cable
Flywheel cable
X2