Bowflex LateralX LX5 Service Manual page 126

15. Bend the edges of the PCBA cover to disengage the inside tabs from
the mounting plate, and remove the cover from the PCBA Slim Control
Board. Carefully disconnect the Power Inlet wire from the PCBA Slim
Control Board.
16. Insert the new Power Inlet cable connector into the Left Lower
Shroud. Using a 17mm wrench, tighten the nut to secure the power cable
connector.
17. Carefully route the new Power Inlet wire and connect the Power Inlet
cable connector to the wiring harness at the Servo Motor.
NOTICE: Be sure the connectors lock. Do not crimp the cables.
18. Carefully align and connect the Power Inlet wire to the connector on
the PCBA Slim Control Board. Reinstall the PCBA cover.
NOTICE: Be sure the connectors lock. Do not crimp the cables.
19. Align the Left Lower Shroud with the push fasteners on the Right
Lower Shroud and move the Left Lower Shroud into position. Push the
Shrouds together so that the Push Fasteners are fully seated.
Using a Phillips screwdriver, attach the Left Lower Shroud to the main
frame. First, tighten the screw in position A, then tighten the screw in
position B, and then tighten the indicated screws in the other positions.
PCBA
cover
Power Inlet assembly
Connector
to shroud
A
126
Power Inlet wire
Connector
to PCBA
Connector to
servo motor
M4 x 40
M5 x 40
B