Bowflex LateralX LX5 Service Manual page 66

LX5/LX5i—Use an 24mm or 15/16" socket wrench (inside of arm) and
24mm open end wrench or adjustable wrench (outside of arm). Pivot the
Adjustable Arms toward the front.
LX5
11. Remove the Endcaps from the Mid Pedal Arms. Using the appropriate
tool, remove the indicated hardware.
Note: The hardware is very tight (factory installed).
or
12. To remove the Mid Pedal Arm, use the dead blow hammer (or mallet)
to strike it on the surface closer to the main frame alternately on either
side of the bearing housing until you drive it off the Crank arm. Set the old
Mid Pedal Arm safely aside.
Note: It may be helpful to rotate the Mid Pedal Arm to allow easier
access to the other side of the bearing housing. Be sure the Mid
Pedal Arm stays aligned on the Crank arm as you remove it, to
avoid damage to the Crank.
Mid Pedal Arm
Mid Pedal Arm
66
Bearing
housing
Bearing