Bowflex LateralX LX5 Service Manual page 40

4. Using a #2 Phillips screwdriver, remove the 6 indicated screws (arrows)
Shrouds at the push fasteners. Remove the Shrouds and Mast Gasket,
and set them safely aside.
5. Carefully disconnect the Actuator Power cable and
Actuator Control cable from the PCBA Slim Control Board.
NOTICE: Do not cut or pinch the wires. It may be
necessary to remove the PCBA cover.
Bend the edges of the PCBA cover
to disengage the inside tabs from the
mounting plate, and remove the cover
from the PCBA Slim Control Board.
6. Using a Phillips screwdriver, remove the indicated screws from the top
of the Cable Actuator and set them safely aside.
X4
X2
Actuator
power
40
PCBA
cover
Actuator
control