Bowflex LateralX LX5 Service Manual page 71

30. Carefully put the "barrel" end (3) of the Flywheel cable in the slot (4)
on the servo wheel on the Servo Motor. Be sure the cable's path around
the servo wheel is the same as it was before removal. Carefully push the
cable into position in the mounting bracket (2). Using an 8mm open end
wrench, tighten the nut (1) on the Flywheel cable to secure the cable.
Servo wheel
5b (X2)
2
1
4
5a (X2)
3
Flywheel cable
31. Using a #2 Phillips Screwdriver, attach the Servo Motor to the frame.
32. Connect the Servo Motor wire to the Lower Data Cable.
NOTICE: Align the clips on the cable connectors and make sure the
connectors lock. Do not crimp the cables.
33. Turn the crank 3 to 5 turns in the direction of the arrow, and check
the tension. On the upper part of the belt, twist the belt at the midpoint
between the pulleys. The belt should not twist more than 90 degrees
(vertical).
!
hazards when you turn the Crank.
If necessary, tighten more. Refer to the "Adjust the
Belt Tension" procedure in this manual.
71