Bowflex LateralX LX5 Service Manual page 19

15. Using a 17mm open end wrench, loosen and remove the indicated nut
from the Left Lower Shroud. Carefully pull the Power Inlet plug out of the
hole toward the inside of the Shroud.
16. Using a #2 Phillips screwdriver, remove the 5 indicated screws from
the Left Lower Shroud. Carefully remove the Left Lower Shroud and set it
safely aside.
Note: Your machine may not match the image. For reference only.
First stage belt tension adjustment
17. To test the Right Drive Belt tension:
On the lower part of the belt, twist the belt at the midpoint between the
pulleys. The belt should not twist more than 45 degrees.
If the tension is correct, go to Step 27.
If the tension is too loose, adjust:
19