Bowflex LateralX LX5 Service Manual page 37

8. Align the new outer Adjustable Arm Shroud with the push fasteners on
the inner Shroud and move the outer Shroud into position. Carefully push
the outer Shroud onto the inner Shroud so that the Push Fasteners are
fully seated.
9. Install the new Adjustable Arm Shroud to the Adjustable Arm assembly
then the lower screw.
10. Move the Adjustable Arm to engage the Mid Pedal Arm bracket. Using
an M24 or 15/16" socket wrench (inside of arm) and 24mm open end
wrench or adjustable wrench (outside of arm), install the indicated screw
and nut. Completely tighten the nut, or torque to 120 Nm (89 ft-lb).
Arm. Fully tighten the hardware.
Note: Installation of the Lateral Link does not require the Lateral Link
Puller.
12. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
37
X2
X2