Bowflex LateralX LX5 Service Manual page 44

Disconnect all power to the machine before you service it.
Some components of the machine can be heavy or awkward. Use a second person when doing the assembly steps involving
these parts. Do not do steps that involve heavy lifting or awkward movements on your own.
Note:
reference only.
1. Remove the Mast Endcap and set it aside. Disconnect the Mast Cables
from the Console Cables.
NOTICE: Do not crimp the cables. Do not allow the cables to fall down
into the Console Mast.
2. Using a #2 Phillips screwdriver, remove the 4 indicated screws.
Carefully remove the Console. Set the Console and hardware aside for
reassembly.
NOTICE: Hold the Console to make sure that it does not fall. This step
may require two people.
3. Installation steps are the reverse procedure.
NOTICE: Do not crimp the Cables. Make sure the Mast Cable connectors
do not fall into the Console Mast. Make sure to connect all
cables. Each connector end can only be connnected to the
the Console Mast.
4. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
X4
44