Disconnect all power to the machine before you service it.
Some components of the machine can be heavy or awkward. Use a second person when doing the assembly steps involving
these parts. Do not do steps that involve heavy lifting or awkward movements on your own.
This procedure requires removal of the Mid Pedal Arm. This arm cannot be re-used once it is removed. Make sure to have a
replacement Mid Pedal Arm available before attempting the procedure.
Note: If you are only replacing one Mid Pedal Arm, it is only necessary to
remove parts from the side that you are replacing.
Your machine may not match the image. For reference only.
from the Handlebar Arms and Handlebar Links.
Be aware that the Handlebar Arm will be loose and will pivot
when the hardware is removed. Safely allow the Handlebar
Arm to pivot downward and come to rest. Be sure to stay out
of the path of the Handlebar Arm.
2. Remove the Pivot Bolt Covers from the Handlebar Arms. Using a 6mm
3. Remove the Handlebar Arms and Wave Washers. Set them safely
aside.
NOTICE: Do not allow the wave washer to fall down into the Engine
Assembly. This step may require two people.
LX5 shown in photos
106