Bowflex LateralX LX5 Service Manual page 128

23. Move the Adjustable Arm end into the Mid Pedal Arm bracket. Using a
24mm or 15/16" socket wrench (inside of arm) and 24mm or 15/16" open
end wrench or adjustable wrench (outside of arm), install the indicated
screw and nut. Completely tighten the nut, or torque to 120 Nm (89 ft-lb).
24. The remaining assembly steps are the reverse procedure.
Note:
Shroud with the Push Fasteners and move the Right Shroud into
position. Push the Shrouds together so that the Push Fasteners
are fully seated. Using a #2 Phillips screwdriver, install the 6
screws.
Self-tapping screws attach the Shrouds to the Frame.
Re-install the Mast Gasket.
Be sure the Handlebar Links are tilted forward. Put the Wave Washers on
the pivot rods.
Be aware that the Handlebar Arms are top heavy, and will
want to pivot when attached onto the Pivot Rod. Be sure to
stay out of the path of the Handlebar.
Align the Handlebar Arm assembly with the pivot rod and attach the lower
Handlebar Arm to the Handlebar Link
25. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
128