Set First Test Report; Change Domestic Telephone Numbers; Change The Telco Arm/Disarm Sequence - Bosch ICP-SOL2-P Quick Reference Manual

14 en | Operating Commands
3.
4.
Delete WE800EV2 Keyfob
1.
2.
3.
Add RADION Keyfob
Set RF receiver as RADION Receiver.
1.
2.
3.
4.
Delete RADION Keyfob
1.
2.
3.
3.4

Set First Test Report

1.
2.
3.5

Change Domestic Telephone Numbers

Set up receiver transmission format as Domestic.
1.
2.
3.
If there is more than one telephone number, repeat Step 2 to Step 4.
3.6

Change the Telco Arm/Disarm Sequence

Telco Arm Sequency (Call Forward On)
1.
2.
3.
4.
Telco Disarm Sequency (Call Forward Off)
1.
2.
3.
4.
2014.06 | 02 | F01U298027
Only use auto-learn mode to configure keyfob RFID. Press [#] key to switch into auto-
learn mode. When icon numbers (1 to 16) flash, press button 1 or 2 of the keyfob. The
panel learns the WE800EV2 Keyfob ID number and the last digit of RFID number displays
on the codepad. Press [#] key to confirm.
Enter [#] key to confirm the operation, or press [*] to cancel.
Enter the Master Code, followed by [1] and the [#] key.
Enter the WE800EV2 keyfob number (301 to 321) you want to delete, followed by the [#]
key.
Press the [*] key to delete the WE800EV2 Keyfob.
Enter the Master Code, followed by [1] and the [#] key (for example, [12341#]).
Enter the RADION keyfob number (301 to 332) you want to add, followed by the [#] key.
Only current keyfob number (1 to 16 ) displays on the ICON codepad.
Use manual mode or auto-learn mode to configure RADION keyfob RFID.
– In manual mode, enter the 9-digit RF device ID number, followed by the [#] key.
– Or press [#] key to switch into auto-learn mode. When icon numbers (1 to 16) flash,
press button 1 or 2 of the keyfob. The panel learns the RADION Keyfob ID number
and the last digit of RFID number displays on the codepad. Press [#] key to confirm.
Enter [#] key to confirm the operation, or press [*] to cancel.
Enter the Master Code, followed by [1] and the [#] key.
Enter the RADION keyfob number (301 to 332) you want to delete, followed by the [#]
key.
Press the [*] key to delete the RADION Keyfob.
Enter the Installer Code, followed by [1] and the [#] key.
Enter the Number of Days (0 to 15) until the first test report is sent, followed by the [#]
key.
Enter the Installer Code or Master Code, followed by [2] and the [#] key.
Enter the telephone number, followed by the [#] key.
Enter the digits for the telephone number, followed by the [#] key.
Enter the Installer Code or Master Code followed by [3] and the [#] key.
Press [1] followed by the [#] key.
Enter the Call Forward On sequence.
Press the [#] key to exit.
Enter the Installer Code or Master Code followed by [3] and the [#] key.
Press [2] followed by the [#] key.
Enter the Call Forward Off sequence.
Press the [#] key to exit.
Quick Reference Guide
Control Panel
Bosch Security Systems, Inc.