Nortel 1000E Upgrade page 185

Figure 105
Application configuration
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
=====================================================================
Please select the application configuration for this Signaling Server.
Please enter:
<CR> -> <a> - Co-resident (LTPS + VTRK + NRS).
<b> - Stand-alone (NRS only - no Call Server).
<q> - Quit.
Enter Choice>
Communication Server 1000E Upgrade
8 Configure the application configuration for this Signaling Server. See
Figure 105.
• If you are planning on enabling the IP Phone TPS, Virtual Trunk TPS,
and optional Network Routing Service (NRS) applications on this
Signaling Server, enter a at the prompt to configure this Signaling
Server as a co-resident Signaling Server.
• If you are planning on enabling only the NRS on this Signaling
Server:
— If this Signaling Server is to be associated with a Call Server,
enter a at the prompt to configure this Signaling Server as a
co-resident Signaling Server. After you finished installing the
Signaling Server software, you can disable the IP Phone TPS
and Virtual Trunk TPS in Element Manager (refer to Element
Manager: System Administration (NN43001-332)).
— If this Signaling Server is not to be associated with a Call Server,
enter b at the prompt to set this Signaling Server as a
Standalone Signaling Server - NRS.
Depending on the application configuration selected, either the
NRS type: co-resident Signaling Server screen (Figure 106 on
or the NRS type: standalone Signaling Server screen (Figure 107 on
page 186) appears.
Installing a Signaling Server
Option 11C Chassis to Communication Server 1000E
Page 185 of 228
page 186)