Loadware Upgrade - Nortel 1000E Upgrade

Installing the software Page 113 of 228

Loadware upgrade

If the MGC loadware is out of date (compared to the loadware on the Call
Server), an upgrade of the loadware occurs based on the Centralized Upgrade
setting defined during the software install and the values set in LD 143. The
default values are set so that the upgrade starts automatically once registration
is achieved with the Call Server.
There are six pieces of loadware that are updated on the MGC. These updates
are downloaded from the Call Server.
-> Received an upgrade request. Preparing MGC for upgrade.
Auto commit option has been enabled.
Upgrade of CSP loadware initiated.
OMM: IP link is UP between Primary Call Server and MGC 1
Upgrade of MSP loadware initiated.
Upgrade of APP loadware initiated.
Upgrade of FPGA loadware initiated.
Upgrade of DBL1 initiated.
-> 0x86f8bc30 (tMGCInst):
Upgrading FPGA Loadware...
logTask: 1 log messages lost.
0x86f8bc30 (tMGCInst): Programming FPGA ...
0x86f8bc30 (tMGCInst): FPGA Upgrade completed.
0x86f8bc30 (tMGCInst): Upgrading Application Loadware ...
0x86f8bc30 (tMGCInst): Gold CSP image upgraded
0x86f8bc30 (tMGCInst): mgcBootLineFix:fixing the bootline
0x86f8bc30 (tMGCInst): Upgrade Application Loadware
completed
0x86f8bc30 (tMGCInst): Rebooting MGC to take the upgrade
in effect.
At this point the IPMGs synchronize with the Call Server.
End of Procedure
Communication Server 1000E Upgrade Option 11C Chassis to Communication Server 1000E