Installing The Signaling Server Software - Nortel 1000E Upgrade

Installing the Signaling Server software

Introduction
Before you begin
Communication Server 1000E Upgrade
The Signaling Server is out-of-service during software upgrade.
This section provides installation procedures for CS 1000 Release 5.0
Signaling Server software on an IBM X306m or HP DL320-G4 Signaling
Server.
CP PM, IBM X306m and HP DL320-G4 Signaling Servers do not
support any Signaling Server software prior to CS 1000 Release 5.0.
CS 1000 Release 5.0 Signaling Server software does not need to be
installed on the CP PM Signaling Server. It is delivered with the
Signaling Server software, operating system, applications and web files
pre-loaded onto the hard drive. Only basic system configuration
parameters need to be entered on the first boot of the CP PM Signaling
Server.
Before installing the software, you must do the following:
• Connect and power up the Signaling Server. See "Connections" on
page 143.
• For CP PM Signaling Servers, ensure that Switch S5 is set to position 2
(to support the internal hard disk drive)
• For IBM X306m and HP DL320-G4 Signaling Servers, you must obtain
the CS 1000 Release 5.0 Signaling Server Software Install CD.
Installing a Signaling Server
IMPORTANT!
IMPORTANT!
IMPORTANT!
Option 11C Chassis to Communication Server 1000E
Page 153 of 228