To Upgrade The Bios; Configuring The 1002Rp Pentium Iii Bios - Nortel 1002rp Maintenance And Diagnostics

January 2007

Configuring the 1002rp Pentium III BIOS

BIOS is the Basic Input/Output System of the computer. It is Flash
ROM-based code. The system is equipped with Flash BIOS, which
enables you to upgrade by running a single program that writes updated
code to the Flash ROM chips.
When to upgrade the BIOS
Do not upgrade the BIOS unless specifically instructed to do so by your
Nortel representative. The CallPilot server is shipped to the customer
with the required minimum BIOS vintage, so an upgrade is only
necessary if Nortel deems this necessary to solve a system problem. The
minimum release BIOS for CallPilot 4.0 is NNCXUA07 or later.
When to configure the BIOS
BIOS configuration is performed at the factory before the CallPilot
server is shipped to the customer. It may be necessary to reconfigure the
BIOS at a customer site after a BIOS or CMOS failure and recovery.
Requirements for upgrading or reconfiguring the BIOS
CallPilot Image CD (1, 2 and 3)

To upgrade the BIOS

You must perform both of the following procedures to upgrade the
BIOS:
1 Upgrade the BIOS (page 205).
2 Configure the SBC (page 207).
1002rp Server Maintenance and Diagnostics
Maintaining the Pentium III SBC card
205