Table of Contents
Advertisement
Sunny Island
8.3 Menu "PARSYS" (3+3), Parameters System
This menu can only be selected after the installer password (level: 1) has been en-
tered.
In the menu "PARSYS" (3+3) you can set the parameters that concern the Sunny
Island itself. Essentially these are the settings for communication and thus the inter-
face configuration.
Especially for three-phase systems changes of these settings can lead
to incorrect configuration which the Sunny Island cannot immediately de-
tect in operation. Therefore changes of interface parameters are only
implemented at the next restart of the Sunny Island (by switching it on
again or via the "RESET" (2+3) menu).
In this menu the operator can also stipulate the number of autostart attempts to be
made after an error has occurred or the DC voltage has been switched on. If this
value is set to 0 (state in which the inverter is delivered) the Sunny Island does not
start automatically.
The start-up attempts based on low-strain operation of the battery
(see chapter 14, parameter "517_BS Tstop") are independent of the
number of autostart attempts set up, even if this has been set to "0"!
BWRI33-12:EE
Fig. 8.5: Menu "PARSYS" (3+3)
- 78 -
Installation & Operating Instructions
SMA Regelsysteme GmbH
Advertisement
Table of Contents
