Table of Contents
Advertisement
Sunny Island
COM3 is an RS232 interface used exclusively for service. A complete software up-
date for the system management processor or the control processor can be made
via COM3. In addition to a PC and a modem elimination cable this requires a soft-
ware tool available from Sam's website.
3.6.1 Assignment of COM1 Interface (Three-Phase Operation)
In a three-phase island grid the COM1 interface is required for synchronization of the
three phases. The three Sunny Islands in one system have to be interconnected with
special 15-pin interface cables available as an accessory (SMA order name "SI-
Synckabel-Set"). The assignment of the SYNC BUS interface is shown in Table 3.2.
Each Sunny Island is equipped both with a plug connector (A) and a socket connec-
tor (B).
PIN
Plug connector A (RS485) top
1
+5 V
2
Sync
3
/Sync
4
DO/DI
5
/DO/DI
6
SPICLK
7
/SPICLK
8
SPIMAOUT/SIN
9
/SPIMAOUT/SIN
10
SPIMAIN/SOUT
11
/SPIMAIN/SOUT
12
AB CONFIG A
13
GND
14
GND
15
GND
Table 3.2: Assignment of COM1 (SYNC BUS) interface
BWRI33-12:EE
Installation & Operating Instructions
Socket connector B (RS485) bottom
+5 V
Sync
/Sync
DO/DI
/DO/DI
SPICLK
/SPICLK
SPIMAOUT/SIN
/SPIMAOUT/SIN
SPIMAIN/SOUT
/SPIMAIN/SOUT
GND
AB CONFIG E
GND
GND
- 44 -
SMA Regelsysteme GmbH
Advertisement
Table of Contents
