Table of Contents
Advertisement
Sunny Island
6.3 Configuration after Restart ("Restart")
If the Sunny Island has already been fully adjusted to an island grid it does not need
to be reconfigured after a restart. All settings are maintained even if the inverter is
switched off.
If you still want to change parameters to optimize the system please follow the in-
structions below:
When you reach the "INIT" (0-0) menu after switching on the DC fuse of the Sunny
Island – as described in chapter 5 – confirm the automatic selection of "Restart" by
pressing [ ENTER ] . This will not change any of the settings already made.
You will thus reach the menu branch selection "SETUP" (0-3) where – as described
in chapter 7.4 – you can change the desired parameters in the corresponding
"PARxxx" (3+3 ... 3+9) menus after entering the installer password in the "PASSWD"
(3-2) menu.
If you have not pressed [ ENTER ] early enough you will reach the menu branch se-
lection "DATA" (0-1). From here it is also possible to reach all menus with the in-
staller password and change the parameters there.
Changes of parameters should always be made in standby mode.
Otherwise the corresponding operating values will change immedi-
ately after pressing [ ENTER ]. Then incorrect entries cannot be
changed fast enough and may lead to damages in the plant!
BWRI33-12:EE
Installation & Operating Instructions
- 68 -
SMA Regelsysteme GmbH
Advertisement
Table of Contents
