Installing The Cm Dp Communication Module - Siemens SIMATIC ET 200SP System Manual

5.4

Installing the CM DP communication module

Introduction
You need the CM DP communication module to use the CPU with a DP master or DP slave.
Requirements
● The mounting rail is fitted.
● The CPU is installed.
Installing CM DP
To install the CM DP communication module, follow these steps:
1. Install the CM DP to the right of the CPU.
2. Swivel the CM DP towards the back until you hear the mounting rail release button click
into place.
3. Slide the CM DP to the left until you hear it click into the CPU.
Figure 5-3
Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ
Installing CM DP
5.4 Installing the CM DP communication module
Installation
71