Table of Contents
Advertisement
Product Overview
2.3
Guide to Commissioning the Fail-Safe ET 200eco I/O
Module on PROFIBUS DP
Introduction
The following table lists all the important steps you need to take to commission the
fail-safe ET 200eco distributed I/O module as a DP slave on PROFIBUS DP.
Steps in Commissioning the Fail-Safe ET 200eco I/O Module
Table 2-3
Step
1.
2.
3.
4.
5.
6.
Note
You must configure and assign parameters to the fail-safe I/O module in STEP 7
before commissioning it.
Reason: The PROFIsafe address of the fail-safe I/O module is assigned
automatically by STEP 7. You must set this PROFIsafe address on each failsafe
I/O -module by means of switches before installing the module.
2-6
Steps in Commissioning the Fail-Safe ET 200eco I/O Module
Procedure
Configuring and assigning parameters to
the ET 200eco 4/8 F-DI in STEP 7
Setting the PROFIsafe address on the
ET 200eco 4/8 F-DI
Installing the ET 200eco 4/8 F-DI
Wiring the ET 200eco 4/8 F-DI
Commissioning the ET 200eco 4/8 F-DI on
PROFIBUS DP
If commissioning was not successful, run
diagnostics on the ET 200eco 4/8 F-DI
See ...
Chapter 3 and Chapter 8
Chapter 4
Chapter 4
Chapter 5
ET 200eco Distributed I/O Station
manual
Chapter 6, Chapter 8 and ET 200eco
Distributed I/O Station manual
ET 200eco Distributed I/O Station Fail-SafeI/O Module
A5E00297494-02
Advertisement
Table of Contents
