Siemens SIMATIC ET 200SP System Manual page 23

System overview
3.3 How are SIMATIC Safety F-systems structured with ET 200SP?
Hardware and software requirements
Fail-safe modules ET 200SP are supported by IM155-6PN ST interface modules as of
firmware V1.1.1, IM155-6PN HF as of firmware V2.0, IM155-6PN HS as of firmware V4.0
and IM155-6DP HF as of firmware V1.0.
You require the STEP 7 Safety Advanced option package, V12 or higher including HSP 54,
for configuration and programming of the ET 200SP fail-safe modules with the SIMATIC
Safety fail-safe system.
You require the F-Configuration Pack V5.5 SP10 or later for configuring and programming
the ET 200SP failsafe modules with the Distributed Safety failsafe system.
You require the F-Configuration Pack V5.5 SP12 or later for configuring and programming
the ET 200SP failsafe modules with the F/FH Systems failsafe system.
ET 200SP fail-safe motor starters are supported by interface modules IM155-6PN BA,
firmware V3.2 or higher, IM155-6PN ST, firmware V3.1 or higher, IM155-6PN HF, firmware
V3.1 or higher and IM155-6DP HF firmware V3.0 or higher.
You require SIMATIC Step 7 V14 or higher for configuration and programming of ET 200SP
fail-safe motor starters. The F-Configuration Pack is not needed for configuration and
programming of the ET 200SP fail-safe motor starter.
Note
Configuration of ET 200SP motor starters, SIMATIC Step 7 V13 or higher, is possible with a
GSD file (GSDML).
Use in safety mode only
Safety mode is the F-I/O operating mode that allows safety-related communication using
safety frames.
Safety mode of motor starters is characterized by the fail-safe digital input (F-DI) and
availability of the 24 V power supply.
You can only use the ET 200SP fail-safe I/O modules in safety mode. They cannot be used
in non-fail-safe mode.
22
Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ