200Sp As A Dp Slave - Siemens SIMATIC ET 200SP System Manual

11.3.3 ET 200SP as a DP slave
Configuration example
To use the ET 200SP distributed I/O system as a DP slave, you need the IM 155-6 DP HF.
Figure 11-6
Commissioning procedure
To commission the ET 200SP distributed I/O system as a DP slave on PROFIBUS DP, we
recommend the following procedure:
Table 11- 6
Step
1
2
3
4
5
6
7
8
Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ
ET 200SP as a DP slave
Procedure for commissioning the ET 200SP as a DP master for PROFIBUS DP
Procedure
Installing ET 200SP (with IM 155-6 DP HF)
Setting the PROFIBUS address on the
interface module
Connecting ET 200SP
Supply voltages
•
PROFIBUS DP
•
Sensors and actuators
•
Configuring DP master (including
PROFIBUS address)
Switching on supply voltages for DP master
Switching on supply voltages for DP slaves
Download configuration to the DP master
Switching DP master to RUN
11.3 Commissioning the ET 200SP on PROFIBUS DP
See ...
Section Installation (Page 63)
Section Interface module
(http://support.automation.siemens.com/
WW/view/en/55683316/133300)
Section Wiring (Page 86)
Documentation of the DP master
Documentation of the DP master
Interface module
(http://support.automation.siemens.com/
WW/view/en/55683316/133300) Manual
STEP 7 online help
Documentation of the DP master
Commissioning
203