Siemens SIMATIC ET 200SP System Manual page 133

Configuring
7.1 Configuring ET 200SP
Requirements for configuration of the CPU
Table 7- 1 Requirement for installing the CPU
Configuration software
CPU 151xSP-1 PN:
STEP 7 (TIA Portal) as of V13 Update 3
CPU 151xSP F-1 PN:
STEP 7 (TIA Portal) as of V13 SP1
CPU 151xSP-1PN (as of FW version V1.8),
CPU 151xSP F-1 PN (as of FW version V1.8):
STEP 7 (TIA Portal) as of V13 SP1 Update 4
Requirements for configuration of the interface module
Table 7- 2 Requirement for installing the interface module
Configuration software
STEP 7 (TIA Portal) as of
V11 SP2*
PROFINET IO: STEP 7
V5.5 SP4 HF1
or higher PROFINET DP:
STEP 7 V5.5 SP2 or higher
Software of third-party
manufacturer
* The TIA Portal supports GSDML specification V2.25. The ET 200SP distributed I/O system is delivered with a GSD file
based on specification V2.3. The GSD file can be installed in the TIA Portal and used without restrictions.
Configuring a motor starter
You configure SIMATIC ET 200SP motor starters in exactly the same way as the I/O
modules of the ET 200SP distributed I/O system. The GSD files can be used with STEP 7
V5.5 SP4 and higher, and TIA Portal V13 SP1 and higher.
132
Requirements
PROFINET IO
•
PROFIBUS DP (optional): With
•
the communication module CM
DP
Requirements
PROFINET IO: As of Support Package HSP0024
•
PROFINET IO: GSD file GSDML-Vx.y-siemens-
•
et200sp-"Date in format yyyymmdd".xml
(http://support.automation.siemens.com/WW/view/en/
19698639/130000)
PROFIBUS DP: GSD file SI0xxxxx.gsx
•
(http://support.automation.siemens.com/WW/view/en/
10805317/14280)
Installation information
STEP 7 online help
Installation information
STEP 7 online help
Manufacturer documentation
Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ