Resetting Interface Module (Profinet Io) To Factory Settings - Siemens SIMATIC ET 200SP System Manual

Maintenance
12.7 Resetting CPU/interface module (PROFINET) to factory settings
12.7.2

Resetting interface module (PROFINET IO) to factory settings

Function
The "Reset to factory settings" function returns the interface module (PROFINET) to its
delivery state.
Reset options
● Using STEP 7 (online via PROFINET IO)
● Using a reset button on the interface module (on rear). Exception: The IM 155-6 PN BA
does not have this reset button. See section Resetting the interface module
(PROFINET IO) to factory settings with a RESET button (Page 253).
Procedure using STEP 7
To reset an interface module to factory settings using STEP 7, follow these steps:
Make sure that an online connection to the interface module exists.
1. Open the online and diagnostics view of the interface module.
2. In the "Functions" folder, select the "Reset to factory settings" group.
3. Click the "Reset" button.
4. Click "OK" in response to the confirmation prompt.
Result: The interface module then performs "Reset to factory settings".
Result after resetting to factory settings
The following table shows the values of the interface module properties after a factory reset:
Table 12- 4
Properties
Parameters
IP address
Device name
MAC address
I&M data
Firmware version
252
Properties of the interface module as shipped
Value
Default setting
Not available
Not available
Available
Identification data (I&M0) available
Maintenance data (I&M1, 2, 3, 4) reset *
Available
System Manual, 09/2019, A5E03576849-AJ
Distributed I/O system