Table of Contents
Advertisement
7 Options
3. Place the arm equipped with the quick coupler on the accessory to engage the accessory
hooks on the bucket or accessory pin.
4. Hold switch (2) in the locked position until the locking pins are completely retracted.
The green light comes on. The control rod is visible (C).
5. Rotate the quick coupler slowly lifting the boom to fully engage the quick coupler to the buc-
ket or accessory.
The control rod must be visible from the driving position.
6. Hold switch (2) in the locked position until the locking pins are completely released.
Note
The locking pins engage on the bucket or accessory to lock it.
The green light comes on. The control rod is not visible.
Make sure that the control rod is retracted into the quick coupler and is no longer visible.
Otherwise check the condition of the interface between the quick coupler and the accesso-
It is forbidden to operate the bucket or the accessory if the control rod is still visible, be-
cause in this case it is not installed on the machine and it may drop during use.
7. Manoeuvre the bucket or accessory to low height from the ground to see if it is locked in the
quick coupler.
8. Turn the switch (1) to OFF.
The light goes off and the alarm stops.
For safety reasons, do not work with the machine until the power switch is in the OFF
54
DANGER
ry (cleanliness, shock...).
WARNING
position.
Advertisement
Table of Contents
