Accessory Change By Direct Coupling; Dismantling The Accessory - Yanmar SV26 User Operation And Maintenance Manual

12 A
CCESSORY CHANGE BY DIRECT COUPLING

12.1 Dismantling the accessory

A & B = Bucket or attachment bore
1. Place the machine on flat ground.
2. Place the accessory at about 5 cm above the ground.
3. Stop the engine.
4. Clean all the parts.
5. Remove the swivel pin from the A bore and the swivel pin from the B bore.
Protect the various elements from dirt and dust.
•
Take care not to damage seals on each bushing side.
•
Verify the good state of o-rings. Replace them if they are damaged.
•
IMPORTANT
107